LCD FRAME ABS-629-701 INSTALLATION IMAGES
Open your LCD screen housing by removing the 4 screws located at the corners.
Cut the QC seal, push and separate the covers simultaneously.
Carefully open the cover and remove the circuit board's screws.
Lift the back cover and disconnect the speaker from the circuit board. Remove the 4 screws and retaining tabs from the LCD panel and the 3 screws holding the button's board.
Remove the LCD component from its housing and disconnect the button's board.
Using a soldering tip, remove the IR remote sensor from the button's board and attach it to the flat ribbon cable supplied with the kit. Use the Shrink Wrap protector to prevent electric shocks. Make sure to keep the same polarity.
Put the kit upside down on a cushioned surface to avoid scratches.
Put the LCD component towards the left side of the frame.
Lift the circuit board to allow the installation of the bracket.
Install the IR remote sensor facing at the 4mm hole located at the right side of the frame and secure it by putting the bracket on top of the LCD component.
Re use the original screws (from the Lilliput case) to attach the bracket to the frame, using a small screwdriver.
Set the circuit board on top of the bracket and align the 4 holes shown in this image to secure it with screws.
Trim the sleeve cover of the SKS cable before connecting it to the screen.
